Fix Digimaster 3 black/white screen

How to do when the Digimaster 3 suddenly black / white screen?

update the EBoot

update the kernel of the digimaster3 was supported recently( one key through updating kernel by SD card). Press the number 8 and press the OK at same time, and comfirm it by ” Press O?“ When the “continue update Firmware” appears, it indicated your device EBOOT program is the old version. So first you should update the EBOOT program and update the Digimaster 3 kernel.

digimaster3 kernel update

Before you update EBOOT, you should install the EBTOOL first.

1. Press the number 8 and OK simultaneously, Press the OK when the ” Press OK to confirm and continue update Firmware”, the updating is beginning.

2. Connect the EBTOOL to the computer via the USB port, then will pop-up the ” Found New Hardware wizard”

3.Click the “Install the software automatically”.

4. If you had installed the digimaster3 before, choose the second ” SEC???SMDK board” in dialog box shown below, click next.

6. Check the the mini USB is connecting the computer, then the Screen will show the

 5. Double click digimaster3

 PC Tool and choose”Kernel Update”

6. Click the “Kernel Update” and choose “EBOOT_20110427.bin” then click “OK” to start EBOOT program update.

7. 10 sec later the DiGIMASTER 3 screen shows a twinkling red “YH” logo and the update is complete.

So now the EBoot is successfully update, turn the power off and update the kernel in an appropriate way.